Why is my set-top box showing red light?
Why is my set-top box showing red light?
Make sure your TV is on the proper channel or input. Make sure your Set-Top Box is on. If your red light is blinking, you will need to check the Ethernet cable at the back of the Set-Top Box. Make sure it is properly connected and secured to your Set-Top Box, as well as your modem.
Why does my Videocon HD set-top box shows only red light and not doing any further process?
Why does my Videocon HD set top box shows only red light and not doing any further process? – Quora. Brother, this is due to an IC in your STB had gone bad. This needs to be serviced by expert technician.
Why set up box light is not working?
CAUSE: The first and most common cause for set top box not working is improper cable connections. SOLUTION: Make sure all the cables are connected in the right ports and none of the connections are broken or obstructed. Refer to the user manual if you have any confusion regarding the same.
How can I fix my Airtel set top box?
Restart the Set Top Box by switching power Off and then On. 5. If unable to view Channel 099 (Default Channel) & 121 (Recharge Info), please call the call center.
How do I reset my amino cable box?
How to Reboot Your Set Top Box (Amino or ADB Converter Box)
- Unplug your STB (Amino or ADB Converter Box) from the outlet.
- Verify you have unplugged the correct cord by checking that all the lights on the STB are OFF.
- Wait 30 seconds and plug the power cord back into the STB.
Why is my Videocon set top box not working?
Switch OFF your d2h product from the mains & after 15 seconds restart it. Please check that the signal cable from the antenna to your d2h product is connected Properly. Due to heavy rains or dense clouds the signal might have been lost, please wait till weather conditions improve.
How can reset Videocon set top box?
Newer Set top boxes Come with Small Reset button at the back of STB. pressing it once will act as an On/Off Switch. Press and hold for 5 Seconds or More and Factory Reset Menu Will appear on Screen. Press ok If you want to reset.
How do I reset my SCV set top box?
On the remote, press MENU > Installation > Factory Default > OK to select Factory Default > enter (0) zero x 4 (0000). STB will now show a Warning prompt, simply press the OK button. You will now be taken to the Channel Search screen where the STB will scan all GD frequencies.