Can I replace a resistor with a wire?

Resistors are used to limit current for one reason or another by the designer of the circuit. Replacing them with a wire will increase current flow and risk some other part of the circuit overheating. A wire has much less resistance than a resistor.

What is a 330 ohm resistor?

Be the first to review this product. 1/4 Watt, +/- 5\% tolerance PTH resistors. Commonly used in breadboards and perf boards, these 330Ohm resistors make excellent LED current limiters and are great for general use. Out of stock.

How do you calculate SMD resistance?

Standard-tolerance SMD resistors use a 3-digit code to mark the resistance value on the part. The first two numbers will indicate the significant digits, and the third will be the multiplier. ‘R’ is used to indicate the position of a decimal point.

How do I know if I have a 330 ohm resistor?

Thus, for 330-ohm resistor, 1st digit is ‘ 3 ‘, ∴ look for color in a chart with value 3, then it’s your 1st color(say orange). The next 2nd digit is ‘ 3 ‘, ∴ look for color in a chart with value 3, then it’s your 2nd color (say orange).

How do you calculate the resistance of a fixed resistor?

This formula tells you that your resistance is always equal to your voltage divided by the current. You can also say that your voltage is equal to your current multiplied by your resistance, or V = IR in equation form, with R = V / I. Your circuit has a voltage of 50 Volts.

What uses a 330 ohm resistor?

Commonly used in breadboards and perf boards, these 330Ohm resistors make excellent LED current limiters and are great for general use.

How do I find the SMD value?

Below are the rules to follow to know the value of EIA-96 SMD resistors.

1. The first two (2) digits or numbers will indicate the significant digits or numbers.
2. The third one “Letter” is a multiplier (in Power of Ten i.e. 10^ something) and then must be multiplied by the first Two (2) significant digits.

How many Ma does a 330 ohm resistor give?

\\$\\begingroup\\$ The resistor is not 330 Ohm “by practise”. The value depends on the voltage drop and what current you want thru the LED. 330 Ohms gets you about 9 mA with a 5V supply and 2.1 V LED. That is no more the right answer than many others.

What is the value of a 4 700 ohm resistor?

For example, a 4,700Ω resistor is equivalent to a 4.7kΩ resistor, and a 5,600,000Ω resistor can be written as 5,600kΩ or (more commonly as) 5.6MΩ. All resistors have two terminals, one connection on each end of the resistor. When modeled on a schematic, a resistor will show up as one of these two symbols: Two common resistor schematic symbols.

What is the typical resistance of a through-hole resistor?

Most of the standard, no-frills, through-hole resistors will come in a carbon-film or metal-film composition. Peek inside the guts of a few carbon-film resistors. Resistance values from top to bottom: 27Ω, 330Ω and a 3.3MΩ.

What is the voltage drop across resistor of 5mA?

So if you have 5V power supply, and want 5mA current through led (5mA usually gives good visibility), you need (5V-3.4V)/0.005A = 320 Ohm resistor. (I.e. this resistance will give voltage drop across resistor of 1.6V, remaining 3.4V drops on LED => 5V total) Red LEDs usually have smaller voltage drop (~2V),…