Where is the diagnostic port on a Toyota Camry?

The OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 – 3 in the diagram below). If not located beneath the steering column, look for the port in the areas indicated by numbers 4 – 9.

Where is my OBD port location?

The most common place to find your car’s OBD2 port is under the dashboard on the driver’s side. Most vehicles have the connector under the instrument panel (aka, the dashboard) on the driver’s side, but some can be found near the center console area or even on the passenger’s side of the car.

Where is the OBD2 port on a 2001 Toyota Camry?

OBD connector location for Toyota Camry XV30 (2001 – 2006)

1. The OBD II socket is located above the pedals.
2. The OBD connector is above the brake pedal.
3. Here is the OBD II port.

How do I find the code for my Toyota Camry?

How to Check OBD2 Diagnostics on a Toyota Camry

1. Hook the OBD2 scanner up to the Toyota Camry’s diagnostic outlet.
2. Power up the diagnostic scanner.
3. Insert the Camry’s key into the ignition and turn.
4. Jot the alpha-numeric trouble code on a piece of paper.
5. Turn the car and the scanner off.

Where do I plug in diagnostic tools?

Plug the standard OBD2 connector into the vehicle’s port located under the driver’s side of the dashboard. Turn on the car to power the scan tool or code reader. If necessary, enter any vehicle-specific information requested. Many tools will ask for the Vehicle Identification Number (VIN).

Does my car have OBD?

All cars and light trucks built and sold in the United States after January 1, 1996 were required to be OBD II equipped. There will be a note on a sticker or nameplate under the hood stating “OBD II compliant” or “OBD II Certified”.

Where is the OBD port on a 2002 Toyota Camry?

OBD connector location for Toyota Camry V50 (1998 – 2003)

1. The OBD2 plug is located under the steering wheel.
2. The OBD socket is above the pedals.
3. The OBD2 diagnostics port.

How do I find my Toyota obd1 code?

Summary

1. Park vehicle and set the emergency brakes.
2. Turn key to position II.
3. Pull the hood release and open the hood.
4. Locate the diagnostic port in the engine bay.
5. Use a copper wire or paper clip to short terminals TE1 and E1.
6. Go back inside the car and count the number of flashes for the check engine lightengine light.

How do I read Toyota error codes?

On vehicles with Start/Stop, press the button twice without touching the brake pedal. All dashboard lights should turn on; the engine should be off. Allow the scanner to power on and select your Toyota model. Select Auto Scan or Full System Scan to read fault codes from all the modules.