How high do you hang a dartboard from the ground?

Standard height from the floor to the bullseye on the dartboard is 5 feet 8 inches, while the oche (distance between the front of the board and the toeline) should measure 7 feet 9.25inches.

What do you put under a dart board?

Dartboard Wall Protectors A dart surround is a foam border that is cut precisely to fit around a dartboard. This offers immediate protection to your wall from any stray darts that misses the board. Most surrounds are only a few inches wide, so the protection they offer is limited.

How do you hang a dart board without nails?

Starts here4:24Use your belt to hang a dartboard on a door – no drilling – YouTubeYouTubeStart of suggested clipEnd of suggested clip58 second suggested clipSo rubber drill we have a 12 side 12 wood drill bit and put a hole through the belt of that positionMoreSo rubber drill we have a 12 side 12 wood drill bit and put a hole through the belt of that position. Okay let’s just the case of laying down the board and fitting about end of the screw.

How far away from a dartboard should you stand?

The official regulations state that it should be 5 feet, 8 inches (or 1.73 meters) from the ground. The measurements are applicable to both steel-tipped and plastic-tipped darts.

What is the distance from dartboard to throw line?

7 Feet 9 and a quarter inch
Setup the dartboard throwing distance to measure 7 Feet 9 and a quarter inch from the front of the dartboard to the front of the Oche (Throwing Line). The throwing distance can also be measures as 93.25 inches, 2.37 meter or 237 centimetres.

Where should a dart board be placed?

Best Place to Hang a Dart Board Find an open space such as the basement, game room, or outside in the backyard. The area should be at least 5 feet wide and 11 feet long. Darts can bounce over 8 feet from the bull’s eye so make sure that you make the proper accommodations.

How do you hang an electric dart board?

More videos on YouTube

1. Begin by marking off the proper height from the floor on your wall (5’8” or 1.73m).
2. Apply the metal Mounting Feet to the back of your dartboard, using the Stabilizer Screws.
3. Drive the Dartboard Center Screw into the pre-drilled hole, leaving space to hang the dartboard onto the Mounting Bracket.

How do you hang a dartboard on a brick wall?

Drill pilot holes at the marked spots, using a carbide-tipped masonry bit. Use the bit size recommended on the package of concrete screws. Position the board against the wall again. Insert one concrete screw through each hole, then tighten the screw with the appropriate screwdriver.

How do you hang an arachnid dart board?

Choose a location to hang the board that is near an electrical outlet, and that has at least 10 feet of open floor space in front of the board. 2. Locate a wall stud, and place a mark 76 3/8” (194cm) up from the floor along the stud (see illustration above). Place another mark 16” (40.64cm) below the first mark.

How do you put a dart board on the wall?

Starts here1:00How to Hang a Dartboard – YouTubeYouTube

How do you throw a dart better?

Starts here2:22How To Throw Your Darts? | Darts Tips for Beginners #3 – YouTubeYouTube

How do you throw a dart properly?

Starts here1:50How to throw like a pro: darts tips – YouTubeYouTube