How do I fix error code E03 on a lazy spa?
Table of Contents
How do I fix error code E03 on a lazy spa?
E03
- Remove the pump from the spa by placing the stopper caps on the inside of the spa over the debris screens.
- Carry the spa pump indoors or to a warmer place.
- Leave this within a warm area for 2 to 3 hours for the internal parts to warm up.
- Once the spa pump has warmed up, the error code should disappear.
How do you fix the error code on a hot tub?
Ensure the spa is full of water, and that the pump feeding the heater is working. Once you have resolved the problem, restarting the spa will get rid of the error code.
What does F3 mean on hot tub?
Filter Cycles The filter program also controls how the spa heater operates as follows: • Standard filter programs (F0, F1, F2, F3): Heater activates anytime water temperature drops 2 degrees below the set temperature (Jets 1 low speed also activates on non-Circulation Pump models).
What does E3 mean on lazy spa?
E03 ERROR CODE AMBIENT AIR TEMPERATURE. REASON, THE TEMPERATURE IS TOO LOW. This error code is visible if the ambient air temperature is too low outside. The spa pump will not run if the air temperature is below 4-6°c.
Why does my lazy spa keep saying E02?
Is there an E02 error code displaying on your Lay-Z-Spa pump? This means your Lay-Z-Spa pump is experiencing a water flow issue. To clean the filter cartridge use luke warm water, run the filter cartridge under the water until the water runs clear. Do not use any detergent, washing up liquid or other chemicals.
What are the codes on a hot tub?
The Big List of Spa and Hot Tub Error Codes
CODE | ERROR CODE DESCRIPTION |
---|---|
CE 04 | Water sensor/pressure switch fault |
CE 05 | Temperature sensor, or water is dangerously hot |
CE 06 | High limit manual reset on heater is tripped |
CE 07 | Stuck heater relay |
What does 616 mean on jacuzzi?
The “616” error code is displayed when your 365 day ClearRay Bulb timer has reached zero. TO reset your ClearRay timer, please refer to our “616” reset instructions here.
How do you fix a low flow in a hot tub?
Solution A: Increase the hot tub water level Switch off the power and remove the filters. After 20 minutes, switch the power back on and run the spa/jets without the filters to see if it clears the flow issue. If the flow clears, switch off the power again, replace the filter and then switch on the power.