How do you reset a motion sensor light?

Turn the light switch on and off rapidly approximately four times. The light will eventually stay on continuously. Once the light is on, turn the switch off, wait five seconds and turn it back on again. The light should stay off and the sensor should be reset.

Why does my dusk to dawn light stay on?

Dusk-to-dawn lighting uses a light sensing photocell to operate your outdoor lights during dark hours. Manually overriding your dusk-to-dawn light turns it off, while overriding your motion sensing light causes it to remain on. A brief power outage lasting no more than one or two seconds also can override your lights.

How do I get my outdoor motion lights to stay on?

One of the quick tricks you can try is to quickly turn the motion sensor ON, OFF, ON to override the motion detection and make the light stay on. To go back to motion detection mode, turn the motion sensor switch off and wait for about 10 seconds, and then turn it on again.

Why does my outdoor light keep going on and off?

Flickering motion sensor lights can be caused by several things: A bad bulb or diode. A pretty straight-forward problem, even high-quality lights tend to go out eventually and sometimes even new ones can malfunction. A bad connection between the bulb or diode and the light fixture itself.

How do you know if your photocell is bad?

If your light burns continuously, then the photocell has gone bad, and the entire unit should be replaced. The life span depends on how often and long it is turned on, but mine usually will last upwards of 10 years, or more.

Can a light set off a motion detector?

Lights can trigger a Motion Sensor. For Motion Sensors which sense Infrared Radiation, lights which quickly change in temperature can cause the sensor to trigger. Motion sensors which use image comparison can also be set off by light when a sudden change in light intensity occurs rapidly.