What lights should be on my Cisco router?

Solid Green Light: Indicates that the upstream channel is connected. Flashing Light indicates the modem is scanning for an upstream connection. Solid Green Light: Indicates that the modem is now online. Flashing indicates the modem is scanning for network connectivity.

What is router act light?

The LEDs (lights) on the Vigor Routers can give a very quick indication of the current state of the Vigor. The most important LED is the ACT. In normal operation mode the ACT will be blinking approximately once per second. If the ACT is On solid or Off completely this would suggest a hardware failure.

What is SYS in router?

The SYS indicator on an AR router is steady on in the following conditions: The device temperature is too high or too low. The card temperature is too high or too low. The system fails to obtain the card temperature consecutively three times.

How do you reset a Cisco router?

1. Prepare the router. Make sure the Cisco router is turned off and the power cord is plugged into both the router and the power source.
2. Locate the reset button. Look for the small factory reset button on the back of the router.
3. Use the reset button.
4. Wait for the reset to complete.

Should the green light on my router be flashing?

Most ATC provided modems have the following lights: LAN: A blinking green light is normal. This indicates traffic/usage on the local network. If your modem is connected to power, and yet no lights are lit, check to ensure the power switch on the back is toggled to the “on” position.

What does Sys mean on my router?

Why is WLAN light flashing on router?

WLAN (Green) – The WLAN LED lights up when the Wireless Local Area Network (WLAN) feature is enabled. If the LED is flashing, the router is actively sending or receiving data over the network.

What happens if I reset my Cisco router?

Like most devices, they have a factory reset button that can be used to completely wipe the device. Factory resetting your Cisco router will remove all of your current settings, including your network name and WiFi password—so be sure to proceed with caution!

How do I restore my Cisco router to factory settings?

Reset Router to Default Configuration

1. With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
2. Find the Reset button on the router.
3. Press and hold the Reset button while you power on the router.
4. Release the Reset button after 10 seconds.

Why isn’t my online light on my router?

Troubleshoot hardware Issues The online light could be off because your router is damaged or defective. In this case, you will need to get it replaced. Another common hardware issue is that the power cable used to attach your router to the wall outlet may be damaged.