Why is PWM mode preferred over DC for motor velocity control?

Motors as a class require very high currents to operate. Being able to vary their speed with PWM increases the efficiency of the total system by quite a bit. PWM is more effective at controlling motor speeds at low RPM than linear methods.

What are the advantages of PWM over variable DC for motor speed control?

If you use PWM far less power has to be dissipated by the regulator since it either off – no loss, or on only small loss due to the current flow and small volt drop across it. So the advantage is greater efficiency, less heat dissipation needed and higher power output for the same type of regulator component.

How can you reduce the speed of a 12V DC motor?

Thus, the speed of a DC motor can control in three ways:

1. By varying the flux, and by varying the current through field winding.
2. By varying the armature voltage, and the armature resistance.
3. Through the supply voltage.

What are the advantages of using a PWM signal over voltage control?

The main advantage of PWM is that power loss in the switching devices is very low. When a switch is off there is practically no current, and when it is on and power is being transferred to the load, there is almost no voltage drop across the switch.

How does PWM change speed of DC motor?

If such a signal is fed to a DC motor, we can change the speed of the motor by changing the duty cycle of the PWM signal. The change in pulse width is created by increasing the on-time (HIGH value) of the pulse while reducing the off-time (LOW value) by the same amount so that the frequency of the signal is constant.

Is PWM bad for DC motors?

PWM has a very good benefit, which is it allows a simple DC motor to rotate from around 20\% to 100\% of RPM UNDER LOAD with higher torque than you get by reducing voltage resistively. A DC motor torque is determined by current, and current is determined by voltage (Ohm’s law).

How do you slow down DC motor speed?

Most DC motors can be slowed down by reducing the supply level of power, Volts, lower volts and resulting less amps, will create less electrical field and will slow motor down. For more gradual speed control there are electronic solutions that are called PWM (Pulse Width Modulation) controllers or Mosfet H bridges.

Is DC better than PWM?

The duty cycle of the PWM signal controls the speed of the fan motor….PWM Fans or 4-Pin Fans.