How does Honeywell gas valve work?

The Smart Valve system uses a 24 VAC powered hot surface pilot gas igniter to ignite the pilot gas. The main gas is ignited in both instances by a pilot gas burner. The Smart Valve system is self-contained, thus eliminating the need for a separately mounted ignition source, usually in the furnace or boiler vestibule.

How does a water heater gas control valve work?

The gas control valve allows the pilot to be ignited, and the lit pilot heats the thermocouple. Once the water heater thermocouple is heated, it sends a signal to the gas control valve which allows the burner to operate, heating the water in the tank.

How do you test a Honeywell gas valve?

Turn off the gas supply valve to your appliance to test whether your valve is capable of shutting down properly. Set the thermostat or the device’s controller slightly above the current room temperature. Locate the hot surface igniter and look for a spark or glow there.

How do I know if my gas control valve is bad on my water heater?

If the burner stays on, turn the gas supply off and replace the gas valve. If the pilot is lit, you have a tank of cold water, the thermostat turned up and the burner does not fire up, either the burner orifice is clogged or the water heater gas valve is bad.

How do you test a gas valve on a furnace?

How to Check the Furnace Gas Valve With a Multimeter

1. Turn off the furnace at the wall control.
2. Take out the bolts in the service panel on the side of the furnace using a nut driver.
3. Pull the wires off the gas valve terminals.
4. Turn the test control on the multimeter to “mV,” which stands for millivolt.

Which way should gas valve is off?

The long side of your handle is parallel to the incoming gas line, which means your gas in on and flowing. By turning the handle perpendicular to the incoming pipe, you are closing the valve and shutting off the gas.

How do I know if my gas control valve is bad?

If you notice strange noises from your furnace, airflow distribution is weak, or it starts to cycle between on and off settings continuously, you likely have problems that don’t involve the gas valve. A service visit to troubleshoot the problem is needed.

How can you tell if the gas valve is bad?

If 24 volts is coming from the board to the gas valve terminals and you don’t hear that little clicking noise the internal valve makes, you could have a bad gas valve. To double-check, take the leads off to the gas valve and check there. Got 24 volts? Then something downstream of that 24 volts is not working.

How do you know if the gas valve is on?

Gas shutoff valves When the long side of the nub or handle is parallel to the incoming gas line, it’s open and the gas is flowing. When it’s turned a quarter turn, perpendicular to the incoming pipe, it’s closed.