How do you make scratched metal shiny?

Stainless Steel Scratches

1. Get Perfect-It Rubbing Compound, Revere Stainless Steel and Copper Cleaner, or even whitening toothpaste.
2. Determine the direction of the steel grain and rub the paste into the scratch with a cloth.
3. Use a damp cloth to remove the excess paste and dry thoroughly with a new cloth.

Does toothpaste remove scratches from metal?

Removing a Scratch with Toothpaste Apply a coat of toothpaste to a soft-bristle toothbrush. Brush over the scratch, again working with the direction of the grain in the metal. Check your progress by wiping away the toothpaste with a wet cloth or sponge. Continue brushing, adding more toothpaste as necessary.

How do you remove scratches from glossy?

Apply a mild abrasive, such as toothpaste, furniture polish, baking soda or plastic polish to the scratch. Try our VuPlex Plastic Cleaning Kit which will also give your surface a gloss finish. Wipe a clean cloth over the paste you have added in a circular motion.

How do you get deep scratches out of metal?

Apply a few drops of oil to a clean microfiber cloth. You can use mineral oil, vegetable oil, or even olive oil. Rub the cloth against the steel, in the direction of the grain, to polish the metal. Add more oil as necessary.

How do you repair scratched metal?

How to Remove Metal Scratches

1. Start out with a good cleaning.
2. Sand away the scratches.
3. Continue sanding with progressively finer grains of sandpaper.
4. Wipe down the sanded area with the cleaning solution.
5. Polish the metal.

How do you remove scratches from steel?

How do you get deep scratches out of a stainless steel sink?

Use a non-abrasive compound such as Bar Keeper’s Friend or Revere Stainless Steel and Copper Cleaner. (In a pinch, you can even use whitening toothpaste). If you’re using a powdered stainless steel scratch removal compound, add enough water—a few drops at a time—to create a paste roughly the consistency of toothpaste.

How do you restore a high gloss table?

With a little filling, sanding and finishing, the original high gloss sheen can be restored.

1. Fill Dents and Gouges. Fill dents, nicks and gouges with a wood filler or wood-specific epoxy.
2. Initial Sanding. Sand the dried filler with progressively finer grits of sandpaper.
3. Apply Finish.
4. Final Sanding and Finish.

Can you buff scratches out of metal?