How do you wire a fluorescent light sequence?

Wire to the next fixture in the series from the fixture you wired first. Using another length of NM cable, connect the black wire that you connected to the first fixture, the black wire from the second fixture, and the black wire from the second length of NM cable together with an orange wire nut.

What are the red and blue wires on a ballast?

The ballast has a hot and neutral wire at one end to receive power, and two blue wires a red one at the other end to supply power to the lights.

How many wires does a ballast have?

Wires on the Replacement Ballast / Transformer The replacement ballast provides 5 wires: black, white, blue, blue (equivalent) and red. Incoming electrical power at the fixture connects to the line BLACK and WHITE wires shown on the diagram.

How do I wire multiple fluorescent lights?

Run a length of two-conductor wire from the existing fluorescent fixture to the new fixture. Loosen the screw on the side of the cable clamps on both fixtures. Feed the ends of the wire through the cable clamps and tighten the screws until the wire is secure.

How do I wire my garage lights in parallel?

At the last light, just connect the incoming black wire to 1 terminal on the light, and then connect the white wire to the other one. This method is called wiring in parallel, so if one light blows, the current can still continue to the other lights to light them up.

How do you wire multiple fluorescent lights?

Can you wire a fluorescent light to a plug?

Having the fixture wired to a plug will allow it to be moved to where the light is needed, and used anywhere there is an electrical socket. Connecting a plug to a fluorescent light fixture is straightforward, but the terminals must be connected properly to avoid hazard from electrical shock.

How do you wire multiple lights to one switch?

You can do this light switch wiring in one of two ways. The most common is to daisy-chain the light fixtures by connecting them to each other and hooking the first one up to the switch. The other way to wire multiple lights to one switch is to connect all of them directly to the switch in a “home run” configuration.

How do you wire a light fixture with a 4-wire cable?

Ok in the 4 wire cable take the black wire and cap it off and push it to the side. Then take the red wire and the black wire from the 3 wire cable and attach them to eachother and to the black wire of the light fixture. Then just connect all your white wires together.

How do you wire a black and white ceiling light fixture?

Insert the toggle bolt through the ceiling hole, and tighten with a screwdriver or drill. Twist the ends of the black ceiling wire to the black fixture wire. Cap off the ends using UL-approved plastic wire nuts. Do the same with the white wires.

How do you find the studs on a fluorescent light?

Identify the stud location with pencil marks spaced identically to the mounting holes in your fluorescent light fixture. If you cannot find a stud, you will need to use toggle bolts. If your fixture has wiring knockouts, carefully open these with a screwdriver.

What are the advantages of Installing fluorescent light fixtures?

Installing fluorescent light fixtures is an inexpensive way to make a dark or dim space bright and cheery. These light fixtures offer great energy efficiency, low heat and a wide spread of lighting. Connecting a fluorescent light fixture is a straightforward process, with relatively few steps, simple tools, and just a small amount of time.