How much weight can a 12V DC motor carry?

Weight: 100 gm(Approx.) RPM: 100 Operating Voltage: 12V DC Gearbox: Attached Plastic (spur)Gearbox Shaft diameter: 6mm Shaft Length: 21 mm Torque: 1.2 Kg-cm. No-load current = 60 mA(Max) Load current = 300 mA(Max).

What is the torque of 12 volt DC motor?

12V 5000RPM High Torque High Speed Brushed DC Motor, 0.4kgm, 60W

How do you calculate the full load torque of a DC motor?

To calculate load torque, multiply the force (F) by the distance away from the rotational axis, which is the radius of the pulley (r). If the mass of the load (blue box) is 20 Newtons, and the radius of the pulley is 5 cm away, then the required torque for the application is 20 N x 0.05 m = 1 Nm.

How much current does a 12V DC motor draw?

At this point it is drawing the maximum amount of current and applying maximum torque. A low voltage (e.g., 12 Volt or less) DC motor may draw from 100 mA to several amperes at stall, depending on its design.

Which DC motor has high torque?

Series wound DC motors are best for applications that require high startup torque, without the need for speed regulation. Like a shunt motor, as a load is applied to a DC series motor, the motor speed decreases, which reduces the back EMF and increases the net voltage.

What is the load of DC motor?

The load converts the mechanical power to some other mechanical or other form. Power from the motor (into shaft) plus power to the load (out of the shaft) equals the change in energy stored in the shaft (the kinetic energy, but in steady state there is no change), Equ [1].

How many amps does a 12v motor draw?

How much power does a continuous duty cycle motor need?

Continuous duty cycle motor is required for applications requiring the motor to work for 10 hours per day or so. for power 15.6wh how much these motor will have torque and how much weight it can carry. How much power is required to lift a 10 kg weight by a DC motor?

What are the specs of a 12V motor?

These are the specs of that motor: Voltage = 12V No load current = 250mA Sall Current = 5 A Stall Torque = 20 Kg/cm Motor Rated RPM = 133 Shaft Diameter = 4 mm Motor Length (without shaft) = 53 mm Motor Diameter = 25 mm

How can I calculate the weight of a DC motor?

It will be the case normally for a DC R = Radius of the shafted wheel / pulley in metres at the edge of which the weight is suspended. Simplify 1,2,3 and get M i.e. Kg weight that can be lifted by your motor at rated speed. Cross check if this torque is less than starting torque of motor from its data sheet.

How far can a 1 hp motor lift 200 pounds?

One HP says that 33,000 pounds can be lifted one foot in one minute. or 1 pound could be lifted 33,000 feet in one minute or any combination that multiplies to 33,000 pounds x feet. So for the question of 200 pounds, 1 HP could lift it 165 feet in one minute. Should we use a smaller motor of 1/10 HP it would lift