What are the few basic safety precautions you need before using jack stand for lifting vehicle?

The following are a few basic jack safety precautions:

1. Only use a jack on a hard level surface.
2. Do not exceed the jack’s specified lifting capacity.
3. Jack only under the designated lifting areas to ensure the vehicle is not damaged and that the jack will not slip.

What must you always use when putting your vehicle on jack stands?

Always Use a Safe Lifting Point to Jack Up the Car. Jack up the vehicle using a solid jacking point, leaving enough room for the jack stand to support the car. If lifting just one wheel, lifting just that corner of the vehicle is a good idea.

What are safety or jack stands used for?

A jack stand is a metal height-adjustable mechanical device that is used to support the weight of a lifted vehicle. Most commonly, they are placed underneath the car as a safety net to protect against a vehicle falling on a body part.

Where should you not place a jack stand?

Only Jack Up from the Subframe and Do Not Place Jack Stands Underneath It. The subframe on subframe-type vehicles is a good jacking point but not a good place to put jack stands because the subframe will be closer to the center of the vehicle and jack stands should be placed out as far as possible.

What are the four safety rules to follow when using a vehicle lift?

Never raise vehicle with anyone inside it. Customers or bystanders should not be in the lift area during operation. Always keep lift area free of debris. Do not hit or run over lift arms, adapters or axle supports.

What is general safety rules?

Seven Basic General Industry Safety Rules

• Keep work areas clean.
• Use the proper tool for the job.
• Always wear the proper PPE for the work task.
• Never work on live equipment.
• Make sure chemicals are properly labeled and stored.
• Communicate hazards to other personnel.
• Stop work when needed to address hazards.

What is a safety stand for cars?

A strong, metal device that can be securely locked at a choice of heights so that it may be used to support an already elevated/raised portion of a vehicle.

What five 5 precautions should be observed if a vehicle is to be raised on a hoist?

Here’s what they advised.

• Read the owner’s manual before you begin.
• Check the specific “lifting points” of the vehicle you’re working on.
• Never exceed your vehicle lift’s maximum capacity.
• Don’t rely on a single lift arm to bear all the vehicle’s weight.
• Choose an auto lift with automatic safety locks.