Why is my computer PXE booting?

When a computer attempts to boot the system using PXE, this usually means that it wouldn’t boot in any other way. Therefore, among the most common issues is a wrong boot priority order, which might’ve got reset on its own. To fix this: Open the BIOS by pressing the BIOS button before the OS starts booting.

How do you get out of a PXE boot?

The issue can be observed by performing the following:

1. Power on the system and Press F1 to enter UEFI setup menu.
2. Enter Network page and disable the PXE mode from Network Boot Configuration.
3. Restart the system.

Why does my computer says start PXE over IPv4?

PXE over IPv4: Means What? This message pops when your computer cannot start from your drive. It happens due to incorrect BIOS configuration. You will see this error message when other booting devices are unavailable.

What does PXE stand for?

Preboot execution environment
Preboot execution environment (PXE), pronounced pixie, is a set of standards that enables a computer to load an operating system (OS) over a network connection.

What are the common errors that are noticed if the boot process fails?

Most error messages are produced by the system BIOS, as it is responsible for most of the functions occur during boot….

A20 Line or 8042 Gate Error	Keyboard Clock Line Failure
DMA Error	Operating System Not Found
Error Encountered Initializing Hard Drive	Option ROM Checksum Failure

How do I enable PXE in BIOS?

Steps to enable PXE boot in BIOS….Operating System

1. Press F2 during boot to enter BIOS setup.
2. Go to Advanced Settings > Boot Menu.
3. Select Boot Configuration and uncheck Boot Network Devices Last.
4. From the Boot Configuration menu, go to Network Boot and enable UEFI PCE & iSCSI.
5. Select either Ethernet1 Boot or Ethernet2 Boot.

How do I enable PXE boot on HP?

To enable the network as a boot device:

1. Press F2 during boot to enter BIOS Setup.
2. Go to the Boot menu.
3. Enable Boot to Network.
4. Press F10 to save and exit the BIOS Setup.