Can a star topology have collisions?

star networks can be wired or wireless. it’s simple to add more devices to the network . better performance than other setups – data goes straight to the central device so all devices can transmit data at the same time and there are few data collisions.

What is the disadvantage of a star topology?

it is expensive to install as this type of network uses the most cable (network cable is expensive) extra hardware is required (hubs or switches) which adds to cost. if a hub or switch fails, all the devices connected to it will have no network connection.

What is collision in network topology?

The problem with this topology is that as the number of network nodes increases, the potential that two nodes would try to transmit at the exact same time also increases. This is referred to as a collision — these network nodes are said to be in the same collision domain.

Is a star topology secure?

In a star topology configuration, the remote branches can communicate securely with the corporate headquarters or central site. However, intercommunication between the branches is not permitted. In star topology, the central site plays an important role; if it fails, all the connections will go down.

How does star topology transmit data?

In a star network, every host is connected to a central hub. In its simplest form, one central hub acts as a conduit to transmit messages. Data on a star network passes through the hub before continuing to its destination. The hub manages and controls all functions of the network.

Why star topology is more reliable?

In a Star Network the best advantage is when there is a failure in cable then only one computer might get affected and not the entire network. Star topology is used to ease the probabilities of network failure by connecting all of the systems to a central node.

What is one drawback of a star topology compared with a bus topology?

Requires more cable length than a linear bus topology. If the connecting network device (network switch) fails, nodes attached are disabled and cannot participate in computer network communication.

Which topology is a collision free topology?

“Rings prevent collisions.” The term “ring” only refers to the layout of the cables. It is true that there are no collisions on an IBM Token Ring, but this is because of the layer 2 Media Access Control method, not the physical topology (which again is a star, not a ring.)

What are the advantages and disadvantages of a star topology?

Comparison Table for Advantages & Disadvantages of Star Topology

Advantages	Disadvantages
Highly efficient	Expensive
Centralized network management	Requires additional equipment
Safe to use	Immobile systems
No point-to-point connections	Wires or cables used in the network get damaged easily

How does a star topology work in computer network?

In a star network, every host is connected to a central hub. In its simplest form, one central hub acts as a conduit to transmit messages. The star network is one of the most common computer network topologies. The hub and hosts, and the transmission lines between them, form a graph with the topology of a star.

How does star network topology work?

In a star topology all nodes indirectly connect to each other through one or more switches . The switch acts as a central point through which all communications are passed. Large networks using a star topology are usually controlled by one or more servers . Hence, the client-server model usually uses a star topology.