How much does an OMAX waterjet cost?
Table of Contents
How much does an OMAX waterjet cost?
When you are attempting to win a grant to supplement the cost of a waterjet, which can start as low as $23,950, be sure to have the exact make and model of the waterjet you want to acquire to ensure you write your funding goals and priorities to be as specific as possible.
Where are flow waterjets made?
With the largest market share, Flow is the world leader in the development and manufacture of UHP waterjet technology. Headquartered in in Kent, Washington, Flow employs approximately 700 employees with offices in North and South America, Asia and Europe.
Who makes omax?
Hypertherm
In April 2019, OMAX Corporation was acquired by Hypertherm, a global 100\% employee-owned industrial cutting solutions leader frequently awarded as a Best Place to Work company and celebrated for its culture of ownership and shared rewards. The integration of the two companies is still in process.
How much is a Flow waterjet?
Hourly Cost To Run An Abrasive Waterjet
| Waterjet Costs | 30HP Pump .010″ Orifice | 50HP Pump .014″ Orifice |
|---|---|---|
| Water Cost | $0.29 | $0.58 |
| Abrasive Cost (at $0.25/lb) | $10.50 | $19.50 |
| Power Cost | $2.59 | $4.29 |
| Parts Cost | $2.98 | $3.46 |
Who makes the best waterjet cutter?
Top 27 Waterjet Cutting Machine Manufacturers in The World
- KIMLA Waterjet.
- Eckert Waterjet.
- TECHNI Waterjet.
- Kimblad Technology Waterjet.
- STM Stein-Moser GmbH Waterjet.
- Shenyang Head Waterjet.
- Soitaab Impianti Waterjet.
- LDSA Waterjet.
How long does a water jet nozzle last?
40-80 hours
The rate of wear can depend on many factors but typically the orifice is replaced after 20-40 hours of active use, the nozzle 40-80 hours of active use.
Who owns OMAX waterjet?
As a wholly owned subsidiary of Hypertherm, OMAX will continue to provide innovative waterjet solutions as well as world-class aftermarket service with the added resources of a global company.
How much does a ProtoMAX cost?
The ProtoMAX starts at $26,950.
What PSI does a water jet cut at?
Typical waterjet cutting pressure is between 50,000 and 60,000 PSI. Many newer systems are pressurized up to 90,000 PSI. The water at this pressure is then released through a small orifice machined into a diamond or saphire, usually in the range of 5 to 15 thousandths of an inch diameter.
How small of a hole can a waterjet cut?
around 0.01 inches
In the conventional shaping of parts, and in the creation of holes and other cavities, abrasive waterjets have usually been able to achieve cutting precision of around 0.01 inches (0.25 mm) without the need for additional compensation to the cut.