What is Brushbond?

Description. Brushbond comprises a two component acrylic polymer modified cementitious coating supplied in ready to mix kits. Brushbond can be simply applied by stiff brush, roller, spray or trowel to obtain the desired texture.

What is brush bond RFX?

Brushbond RFX is an high performance elastomeric cementi- tious coating used for waterproofing and to protect atmospheri- cally exposed reinforced concrete structures from attack by acid gases, chloride ions, oxygen & water. Brushbond RFX is suitable for all types of structures including those in coastal environments.

How do I apply fosroc waterproofing?

Starts here5:08Water Proofing Solution Fosroc Brushbond – YouTubeYouTubeStart of suggested clipEnd of suggested clip59 second suggested clipAfter first coat is applied. Six hours drying time is left. So that that material gets cured. TheMoreAfter first coat is applied. Six hours drying time is left. So that that material gets cured. The second coat is then applied in exactly 90 degrees or in a perpendicular direction to form a mesh.

How do you mix a Brushbond fosroc?

Starts here5:59BRUSHBOND RFX – YouTubeYouTube

What is the use of fosroc?

To provide excellent acceleration of strength gain at early ages and major increases in strength at all ages by significantly reducing water demand in a concrete mix. Particularly suitable for precast concrete and other high early strength requirements.

How do you use fosroc Nitobond SBR?

A slurry primer should be prepared consisting of 1 volume Nitobond SBR to 1 volume clean water to 3 volumes fresh cement. To obtain a smooth consistency, the cement should be blended slowly into the premixed liquids. The slurry primer should be stirred frequently during use to offset settlement.

What is fosroc material?

Fosroc is a global manufacturer of high performance chemicals and materials for the Construction industry. Fosroc’s tailored Constructive Solutions are developed combining our extensive range of products with expertise and experience to meet the needs of the construction industry.

How do you use a SBR polymer?

Apply a thin layer of bonding coat as given above. Apply the mortar onto the surface in a layer of 20–30 mm thickness. This type of polymer mortar should be used for all repair jobs for optimum performance. Cured plaster with SikaLatex® SBR would harden faster and would be watertight.

How do you use a Conplast SP430?

Normal dosage rate is 0.5 to 2\% of cement/cementitious content, depending on required. Optimum dosage should be determined by site trials. A recommended dispenser should be used. Conplast SP430 should be added directly to the mixer, preferably at the same time as the mixing water.

What is fosroc used for?

Renderoc LA has been specifically developed for the repair of large areas of concrete where access is restricted or where reinforcement is congested. It is suitable for use where excellent chloride and carbon dioxide resistance is required or for repairs to concrete affected by alkali-silica reaction (ASR).

How do you mix SBR latex?

Mix SBR LATEX (M) : water in a 1 : 1 ratio. Use a maximum of 25 ltr of this solution in a mix containing 50 kg of cement and 150 kg of sand. This will yield approximately 100 litres of mortar which will cover 10 m2 to a thickness of 10 mm.