Blog

What is the section called on a floor plan for working drawings?

What is the section called on a floor plan for working drawings?

Section. A section drawing looks a bit like an elevation, but it actually shows a cross section through the building. You’ll see that the drawing below is called ‘Section AA’. This means it represents the section view through the invisible line on the floor plan between the two points marked ‘A’.

Why is important to know the parts of the floor plan before drawing a floor plan?

Floor plan layout is an important initial step to creating the right kind of space. Having a clear floor plan is also essential in such large spaces to guide the public either with interactive or printed floorplans. They are used as a way to establish wayfinding signage.

READ ALSO:   Can you substitute feta for goat cheese?

How do you find the section of a drawing?

When sketching an object or part that requires a sectional view, they are drawn by eye at an angle of approximately 45 degrees, and are spaced about 1/8” apart. Since they are used to set off a section, they must be drawn with care. It is best to use the symbol for the material being shown as a section on a sketch.

What is a building section drawing?

A ‘section drawing’, ‘section’ or ‘sectional drawing’ shows a view of a structure as though it had been sliced in half or cut along another imaginary plane. Plan drawings are in fact a type of section, but they cut through the building on a horizontal rather than vertical plane.

When drawing a floor plan what is drawn first?

There are a few basic steps to creating a floor plan:

  • Choose an area. Determine the area to be drawn.
  • Take measurements. If the building exists, measure the walls, doors, and pertinent furniture so that the floor plan will be accurate.
  • Draw walls.
  • Add architectural features.
  • Add furniture.
READ ALSO:   How do I determine the MIME of a file?

How do you draw a section line?

Section Lining Section lines are very light. When sketching an object or part that requires a sectional view, they are drawn by eye at an angle of approximately 45 degrees, and are spaced about 1/8” apart. Since they are used to set off a section, they must be drawn with care.

https://www.youtube.com/watch?v=juwhVpe6kgA