Can a pocket door be installed on a load-bearing wall?

Installing a pocket door in a load-bearing wall requires replacing the old header with a longer one. Creating the opening for the new header may require temporary ceiling support while the header goes in (you may want to consult a pro for this). A wall with pipes isn’t a good candidate for a pocket door.

How much does it cost to put an opening in a load-bearing wall?

To remove a load-bearing wall, construction will likely cost between $1,200 and $3,000 if you have a single-story home, and between $3,200 and $10,000 for multi-story homes. For a partition wall, the cost is between $300 and $1,000.

Can you modify a load-bearing wall?

You can remove either type of wall, but if the wall is load bearing, you have to take special precautions to support the structure during removal, and to add a beam or other form of support in its place. If you’re not sure, hire a contractor or structural engineer to help you figure it out.

How wide can a doorway be on a load bearing wall?

Any opening that’s 6 feet or less can have just one 2×4 under the beam. This creates a bearing point 1.5 inches wide. Any opening wider than 6 feet should have a minimum of two 2x4s under each end of the beam. CLICK HERE to get FREE & FAST BIDS from local bearing wall carpenters.

Can I put French doors in a load bearing wall?

You need a structural engineer to look at it. Anything is possible, but it comes down to cost. You need a major beam above the door. It doesn’t need to be exposed but it does need to be structural (load supporting).

Do pocket doors require thicker walls?

A pocket door requires a “sleeve” inside the wall to retract into. The existing wall should also be thicker than 4 inches, as the standard pocket door thickness is about 2 inches.

Do basements have load bearing walls?

Walls that run down the center of the basement are more likely to be load-bearing than others. Depending upon the span of the floor joists, additional support is often needed to carry the weight of the floor and the house. The center of the basement is the most efficient spot for this task.

How much does it cost to put a door in an interior wall?

Interior Door Cost Calculator

National Average	$732
Typical Range	$361 – $1,134
Low End – High End	$150 – $2,235

https://www.youtube.com/watch?v=KTclHKF0ggI