How do you lift an empty water heater?

Use a hose to lift a water heater Many of us have the strength to lift an empty heater up but don’t have the grip. An easy solution is to take a short piece of tubing or an old garden hose that is about 3 feet long and wrap it around the back of the heater so that you can hold onto each end with your hands.

How do you put a pan on a water heater?

3 Answers. The only slightly easy way is to drain the water heater of all water. Hopefully the tank is connected to the water supply pipes with flexible hoses and not soldered copper. The tank is now ready to be raised so the new “Smitty” pan can be slid underneath.

Should I raise my water heater off the floor?

Your gas water heater should be 18 inches off of the ground, as per the National Fuel Gas Code. This rule is in place for the safety of you and your family, to help prevent fires and even explosions in the event that a flammable substance is spilled near your gas heater.

How much does it cost to install a drip pan under a water heater?

Other relevant repair requests include installing or replacing a safety expansion tank, at $90 to $135. Or installing a Floodmaster Leak Dectection shutoff system in the vicinity of $240 to $295. While replacing a drain pan should cost $85 to $110.

Does a hot water heater need a pan?

Pans & Drains It’s generally recommended, and required, to install a drip pan with a drain line beneath your hot water heater tank. Especially if you water heater is in your home or basement, a leak could cause lots of water damage. A pan and drain eliminate this possibility.

How big should a water heater drain pan be?

The pan shall be not less than 11/2 inches (38 mm) deep and shall be of sufficient size and shape to receive dripping or condensate from the tank or water heater. The pan shall be drained by an indirect waste pipe of not less than 3/4 inch (19 mm) diameter.

How high should a water heater be off the floor?

According to the Uniform Plumbing Code, a natural gas tank water heater should be installed at least 18 inches from the ground.

How do I raise my water heater?

Gas or electric water heaters

1. Start by turning off power to the water heater at the circuit breaker.
2. Find the access panel for the thermostat(s) and use a screwdriver to remove the panel.
3. Peel back the insulation.
4. Use a flathead screwdriver to adjust the thermostat up or down.

Is it code to have a pan under hot water heater?

So, is a drain pan required under a water heater? In most cases, Yes. If your water heater is installed in an attic or ceiling space or inside the interior living space, a drain pan is required under your water heater. Drain pans are not required under the water heaters installed in garages in most states.

Should there be water in the pan under my water heater?

A water heater pan, also known as a water heater drain pan, is a pan that sits underneath your water heater to collect water in the event of a small leak. Ideally, they should be dry—but if you’re finding water in your water heater pan, that means your heater is leaking.