How do you take the back off a watch without a tool?

Using a Rubber Ball on a Screw-Back Watch. Purchase a soft, mashable rubber ball. Rubber balls often have enough grip to pry off watch backings. Choose a rubberized ball that is both squishy and tacky so it can latch onto your watch’s back.

How do you open the back of a watch at home?

In this case, simply flip the watch over, grip it in one hand by the watch strap, and hold the friction ball against the case back with your other hand. Apply some pressure and rotate the ball counter-clockwise – if the case back is loose enough, it should unscrew fairly easily.

What tool is used to take the back off a watch?

A case wrench will use fitted small pins to fit tightly to the back and unscrew the case back and the using a watch case holder can help hold the watch safely while you turn the tool. Other watch tools like the crystal or case press will press on friction watch backs and fit watch crystals in the same way.

How do you remove the back of a watch?

With a screw-off type of back, use a special case tool that fits into the individual slots on the back of the watch. Insert the lugs of the tool into each slot, and twist counter-clockwise to remove the back. If the watch has screws holding the cover on, remove the screws with a small screwdriver.

How to remove the back of a watch?

Screw Off Watch Back: The first thing you will notice with a screw off type is that the back will have notches located near the edges.

Snap Off Watch Back. If the back of your watch does not have any screws or notches,there is a good chance that the back is a snap off type.

Watch Back With Screws. Such Kind of watch backs are probably the easiest to identify as the watch’s back will have four of more screws.

How to remove watch back?

Purchase a soft,mashable rubber ball. Rubber balls often have enough grip to pry off watch backings.

Place the watch down on a flat surface. Although you can hold the watch in your hand while you work,placing it on a flat surface will allow you

Press the ball firmly into the watch’s backing. The rubber ball will need to press itself firmly against the backing,particularly the screw notches.

Twist the ball counterclockwise. Most watch models will loosen when turned counterclockwise and tighten when turned in the opposite direction.

Use the ball to loosen,but not remove,the backing. Once the backing is loose enough,you can use your fingers to remove it entirely.

Use the rubber ball again to put the backing on afterward.