What happens if you use wrong contact solution?

If you happen to accidentally put hydrogen peroxide solution directly into your eye, it will cause a significant burning sensation and can even be quite painful. Remove the lens immediately and flush your eye with sterile saline.

Can you use regular contact solution in a hydrogen peroxide case?

Never share solution that contains hydrogen peroxide. Other people might confuse your solution with multipurpose solution and not follow instructions. This could result in damage to their eyes. Always use the special contact lens case that comes with each new bottle of solution.

How long does it take for Clear Care to neutralize?

about 6 hours
Clear Care has a special lens case with a built-in neutralizer—a ring of platinum that reacts with hydrogen peroxide—that causes the hydrogen peroxide to turn into water. The entire process takes about 6 hours.

Is Clear Care supposed to bubble over?

You really don’t have to do anything other than a rinse with saline before wearing. That bubbling is caused by the chemical reaction taking place in your case. In case (no pun intended) you didn’t notice, the case has a small vent hole in the lid. That allows the gas to escape during the disinfection cycle.

What should I do if clear care or Clear Care Plus solution accidentally gets into my eyes straight from the bottle?

What should I do if CLEAR CARE ® or CLEAR CARE ® PLUS Solution accidentally gets into my eyes straight from the bottle? Immediately remove your lenses and wash your eyes with large amounts of water or sterile saline for a few minutes. If burning and/or irritation continues, call your eye care professional right away.

What happens if you put contacts in water instead of solution?

Many people who wear contact lenses do not know that contact lenses and water are a bad combination—even when showering, swimming, or using a hot tub 1-4. Water can cause soft contact lenses to change shape, swell, and stick to the eye.

Can I soak my phone case in hydrogen peroxide?

For more stubborn stains, soak the case in vinegar and baking soda OR cover with hydrogen peroxide (this should always be a last resort)!

Can you mix hydrogen peroxide and stain remover?

Mix one part blue dish soap with two parts hydrogen peroxide. Apply to the stain, let sit for 10 minutes (or longer), and rinse. (Always perform a spot check first to a discreet area of fabric.)

How long should contacts sit in solution?

Soak at least 4 hours. Remember to always use fresh solution – discard solution from lens case after each use.

How long are you supposed to rinse your eyes if they get splashed with a chemical?

Flush the Eye Flush with lukewarm water for 15 to 30 minutes. For severe burns, which are commonly caused by household drain cleaner, continue flushing until you see a doctor or you arrive in an emergency room.