What needle do you use for sequin fabric?

First things first, you’ll be needing some extra sharp fine point needles for your machine – size 70 is ideal – and make sure that you have plenty spare! Cut a scrap of your sequin fabric and put it aside.

Why does my sewing machine keep breaking the thread?

The upper thread tension could be set too tight. Set the tension to the best thread tension setting or less. Make sure the spool of thread is installed correctly using the correct size spool cap for the size of spool. Check that the bobbin is wound so that it about 80\% full and that the thread is evenly wound.

How do you keep sequins from falling off?

Spray a light coat of hairspray over the glitter for an extra layer of protection before washing. Then, wash the item in cold water on the delicate setting and lay it flat to dry. Never put it in the dryer, as the heat will melt the glitter.

Why is my needle hitting my walking foot?

There are several reasons why the needle keeps hitting the presser foot/needle plate: 1. The presser foot you are using may not be appropriate for the type of stitch that you want to sew. Check that the needle is not bent, if so replace the needle.

How do you stop a sewing machine needle from bending?

To avoid bending your needle, try to slow down while you’re sewing or use a sharper needle. Sewing machine needles also have natural flaws or burs that happen during manufacturing. You will occasionally come across a needle that is bent or damaged before you insert it into your machine.

Why does my sewing machine keep breaking needles?

The bobbin cartridge is in upside down. The user is pulling too tightly on the fabric while sewing. The needle is too fine for the fabric being sewn. If after checking these possibilities and making the appropriate corrections as needed, your sewing machine continues to break or bend the needle, it may be time to take it in for repairs.

What happens if you sew over pins in a sewing machine?

If your needle hits a pin just right, it can break. However, typically what happens when you sew over pins is that your needle gets bent. Eventually, that bent needle will hit your bobbin case, feed dogs, or needle plate, and break because it is out of alignment. Never pull on your fabric as you feed it through your sewing machine.

Why is it important to take care of your sewing machine?

Even if you take care of your machine it is easy for needles to become damaged or blunt over time. Make sure you always have a few spare needles on hand and take the time to check your needle for damage before you start a project. It can be tempting to pull the fabric as you sew.