Why is my straight stitch not working?

If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.

Why is my sewing machine making uneven stitches?

The most common reason for uneven stitches is old or inferior thread. Another cause for uneven stitches is the fabric is being pulled while sewing. It is also crucial to check that the bobbin is correctly threaded in the bobbin case, to prevent uneven stitches.

What should the tension be for a straight stitch?

The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.

Why are my stitches skipping?

Skipped stitches are usually caused by an old or worn needle. With every stitch, there is friction placed on the point of the needle and with repeated action, the needle experiences abrasion. Over time, the needle becomes dull and doesn’t perform well. This results in skipped stitches.

What does a good straight stitch look like?

Straight Stitch When it’s just right, your stitch will look like the one in the middle. Here’s the same stitch on the underside of the fabric. The middle stitch still looks ideal, but the puckering is even worse with the stitch on the far left.

What should my straight stitch look like?

Straight Stitch When it’s just right, your stitch will look like the one in the middle. The one on the left is too tight, causing the fabric to pucker, while the one on the right is too loose, making the stitches loopy.

How do you adjust tension when sewing?

Changing Bobbin Tension You should see a small screw on the flat/closed side of the bobbin case. Turning the screw a tiny bit counterclockwise will loosen the bobbin tension; turning it clockwise will tighten the tension.