Can I put plywood over insulation in attic?

Once the insulation is down, you can turn your attic into valuable storage space by covering the floor with plywood. It will also make the attic a safer place in which to walk.

How do you store plywood for attic storage?

Carry a piece of plywood to one of the far corners of the attic and lay it on top of the installed boards. The plywood should be perpendicular to the joists so that a signal sheet spans multiple ceiling joists. Cut the plywood to fit so that each end of the plywood boards lands at the exact center of a floor joist.

Can I lay plywood in attic?

An attic can be floored with 1/2″ CDX plywood, if it is being used only for storage. However, the same can’t be said if you are planning on using the space as a living space. In that case, you will need to use 3/4″ thick plywood. As an alternative, 3/4” OSB can be used.

What kind of wood do you use for an attic floor?

You need 3/4-inch plywood. The thinner plywood is acceptable when the joist spacing is 16 inches. If you plan to finish the floor in the attic and turn the room into a living space, however, you should always use 3/4-inch plywood.

How thick should attic insulation be?

about 10 to 14 inches
Insulation levels are specified by R-Value. R-Value is a measure of insulation’s ability to resist heat flow. The higher the R-Value, the better the thermal performance of the insulation. The recommended level for most attics is to insulate to R-38 or about 10 to 14 inches, depending on insulation type.

Is my attic strong enough for storage?

As long as they are not damaged, the joists should be strong enough to allow you to move around in the attic for an inspection and to provide storage for typical boxed items. The joists should support your weight, but the space between them almost certainly will not.

What is RTD grade plywood?

Specifically, it refers to plywood that has been manufactured using a Resistance Temperature Detector. This is a device used during the manufacturing process that provides a highly accurate reading of the temperatures achieved during the bonding process.