Can you use a toilet plunger on a car dent?

Run inside and grab your plunger. This method works well for small to medium-sized dents and dings in your car. A cup plunger works much better than the flange plungers commonly used for toilets. Stick the plunger to over your dent and start plunging until the dent pops back into place.

Can you pop out dents with hot water?

To remove a dent from your bumper, you need to make it more malleable. This can be accomplished by dousing the dent with hot water. Heat water to boiling in a pot or big tea kettle and pour it over the dent. Wearing gloves to protect your hands, quickly reach behind the bumper and push out the dent.

Does boiling water work on car dent?

Make sure to keep on pouring the water until the plastic softens and you are able to bend the car dent back into place. Using boiling water on the car part is just as likely to cause further damage, which will only increase the cost of repair.

Will boiling hot water damage car paint?

The heat makes the metal more expandable and malleable, allowing it to be pushed and pulled easily. Pouring hot water over metal also has its problems. It could warp the metal out of shape, make it less sturdy; it could even ruin your paint job if your paint isn’t up to par.

How do I get a dent out of my car door?

First, heat the dent with the hairdryer approximately six inches away for about 30 seconds. Then cover the dent with a piece of aluminum foil and rub dry ice over it. The rapid change from hot to cold should make the dent pop out within a minute or so. Another temperature trick involves boiling water.

Does hot water and plunger remove dents?

You’ll need a pot of very hot water and a simple plunger. Put the plunger over the indented area and pull straight out. Your dent should pop right out. If you’re working on a bumper, you can also reach behind the dented surface to push the dent out.

How do you get a dent out of a car door?

Start off by heating the car dent with the hair dryer at its highest temperature, which will expand the plastic of the car. As soon as it’s hot enough, grab the can of compressed air, turn it upside down, and begin spraying that same area. Since the cold air will cause the plastic to contract, the dent will pop out.

How do you get a small dent out of a car with hot water?

If you have a dent in your car’s or truck’s bumper, you can remove it and apply boiling water to make it easier to push the dent out of the plastic. Just heat boiling water and pour it over the affected area. Reach your hand behind the dent and push it out with your hands.