Where is the reset button on a Kenwood?

The reset button is a small triangle button that is usually lit up too; hence, it is easy to identify. You can find it at the top left corner of your stereo. Hold on to the reset button for five seconds for a soft reset. A soft reset will retain your customized settings.

How do I reset my touchscreen radio?

Step 1: Try Rebooting The Stereo Rebooting often has the miraculous power of fixing technological devices, so you might get lucky! Most devices can be rebooted by pressing and holding the power button for 5 to 10 seconds.

What does HF Error 68 mean on a Kenwood radio?

The unit cannot communicate with
ö “HF ERROR 68” Í The unit cannot communicate with the cell-phone. ò Cycle the power switch. If this message still appears, press the Reset button on the control unit.

Why is my radio screen not working?

A damaged or defective fuse might lead your car radio display not to work. This particular fuse sits right between the display unit and the power line. If you installed a newer stereo system by replacing the stock one, there might be an issue where the aftermarket stereo won’t turn on due to a defective fuse.

Why did my car radio suddenly stop working?

Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. If the radio itself will not turn on, chances are good that there’s one or more blown fuses causing the problem. A damaged antenna means that your radio isn’t able to receive signal from stations.

Why does Kenwood say protect?

Kenwood equips its receivers with a protection mode to safeguard them. Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.

How do I get my Kenwood out of standby mode?

Press and hold the button with the magnifying glass and return arrow to exit. Hopefully this will work for you.