How do we design a RCC building manually?

Architectural Plan:

1. Mark columns.
2. Join columns to mark primary beams. There will be tertiary beams resting on primary beams.
3. Mark all beams.
4. Now mark slabs.
5. Design slabs.
6. Now beams will be calculated each individually.
7. Columns: Assume dimensions 500 mm x 300 mm.
8. Net load from columns will be used to design footings.

How do I manually create RCC columns?

RCC Column Design

1. Fck = 20 N/mm2.
2. Fy = 500 N/mm2.
3. Ag = Gross area of Column.
4. Area of Steel in concrete(Asc) = (1/100) x Ag.
5. Area of Concrete(Ac) = Gross area of column(Ag) – Area of steel(Asc) Ac = Ag – 0.01 Ag.
6. Ac = 0.99 Ag.
7. Pu = Axial load on Column (600 x 1.5) = 900 KN.

How do I create a slab manually?

The effective depth d of two way slabs can also be assumed using cl. 24.1,IS 456 provided short span is <3.5m and loading class is <3.5KN/m….Or, the following thumb rules can be used:

1. One way slab d=(L/22) to (L/28).
2. Two way simply supported slab d=(L/20) to (L/30)
3. Two way restrained slab d=(L/30) to (L/32)

What is design load in RCC?

In a general sense, the design load is the maximum amount of something a system is designed to handle or the maximum amount of something that the system can produce, which are very different meanings. In structural design, a design load is greater than the load which the system is expected to support.

What is K in concrete design?

Calculate the K = M / ( b d2 fck ); where the “M” is the applied bending moment, “b” is the width of the beam, “d” is the effective depth and “fck” is characteristic cylinder strength of the concrete. …

Which software is used for slab design?

SkyCiv Slab Design Software Design complex slabs (via plates) from SkyCiv Structural 3D analysis software. The software allows users to easily assign different reinforcement regions, perform design checks and optimize reinforcement as per ACI and EN requirements.

https://www.youtube.com/watch?v=o6s3Xuj5owI