How do you calculate steel in Etabs?

To know the qty of steel one has to design the member there is an option called output summary there u ill get the ppm ratio r rebar for the respective member.

How do you take quantity from Etabs?

Yes we can estimate through E-tab 15 and 16 version.

1. By clicking material summary(it will give you the total length of each member and from that you can calculate the quantity)
2. Display-> list tables->model->structure data->material list by section.
3. 2nd option gives you total density as per your provided sections.

How do you calculate rebar percentage in Etabs?

How to extract reinforcement percentage from ETABS?

1. Run your model and do concrete design.
2. God to file → print tables → concrete frame design.
3. Select output summery and rtf format and press OK.
4. Save file and open the same.
5. Copy the table and paste in excel and do the manipulation you want.
6. Enjoy ETABS.

How do you calculate the AST of a beam?

It is the area of the tension steel (bar). there are diffrent minimum area for tension in many codes but it is generally taken as P min=Ast min=0.5/fyk, fyk=the characterstic compressive strength of the steel. Note that the charactherstic compressive strength of mild steel is approximately equal to tension.

How is shear reinforcement calculated in Etabs?

Shear Reinforcement design results are given in the form of Asv/sv. For example, if you adopt 2 Legged 8mm stirrups for the required shear 455 sqmm/m, then, spacing of stirrups (sv)=2×50/455=. 219 m or 219 mm.

What is OS in Etabs?

If you are getting the O/S message, then it means that the member can not be designed properly according to the design code and that it fails. You could think of O/S as an “overstressed” warning. If you see it, you should either decrease the load on that member or increase the capacity of the member.