Questions

What is rip what is the use of RIP?

What is rip what is the use of RIP?

Routing Information Protocol (RIP) is a distance vector protocol that uses hop count as its primary metric. RIP defines how routers should share information when moving traffic among an interconnected group of local area networks (LANs).

Is Rip still used?

Welcome to the heart of networking: the routing protocols. RIP, like all routing protocols, is designed to disseminate network information pertinent to routers. At the most basic level, routers need to know what networks are reachable and how far away they are. RIP does this, and it’s still widely used today.

Is Rip Cisco proprietary?

Routing Information Protocol (RIP), version 2, is a non-proprietary distance vector protocol that is easy to implement in a network infrastructure. All CCNA students need to know how to successfully implement RIP 2 on a Cisco router.

READ ALSO:   Are pre and post-workout meal necessary?

Why RIP is not used in Internet routing?

Since any routing update in RIP will take up great bandwidth, the resources for critical IT processes are hence limited. The hop counts of RIP are limited to 15 hops, so any router beyond that distance is considered infinity, and hence unreachable.

Does RIP use link state?

RIP works on Bellman Ford algorithm. OSPF works on Dijkstra algorithm. It is a Distance Vector protocol and it uses the distance or hops count to determine the transmission path. It is a link state protocol and it analyzes different sources like the speed, cost and path congestion while identifying the shortest path.

Should I turn on RIP?

RIP is a dynamic routing protocol. Unless you have multiple routers you need to distribute routes to there really isn’t any reason to run it. All it will do is put extra traffic on the wire and eat up a few cpu cycles on your router. The con to using it is that it will flood your network with updates periodically.

READ ALSO:   Which organ system am I I contain the kidneys and urethra?

Is OSPF better than RIP?

OSPF routing protocol has complete knowledge of network topology, allowing routers to calculate routes based on incoming requests. OSPF protocol has no limitations in hop count, unlike RIP protocol that has only 15 hops at most. So OSPF converges faster than RIP and has better load balancing.

Can RIP be used in a large network?

The hop counts of RIP are limited to 15 hops, so any router beyond that distance is considered infinity, and hence unreachable. The convergence rate is slow. When any link goes down it takes a lot of time to choose alternate routes.

Why is RIP not use in large networks?

RIP cannot support an internal network with more than 15 hops within the same network. A router counts the hops a packet makes as it crosses other routers on the way to its destination. RIP cannot support variable-length subnet masking.