How do I get a smooth finish with Mod Podge?

For a very smooth finish, wet a piece of #400 grit sandpaper with water and sand lightly between coats. Wipe dry and polish with #0000 steel wool on the final coat. To avoid tackiness, use a clear acrylic spray. Add a protective coat of Mod Podge to your project using a sponge or flat brush.

How does Mod Podge prevent brush strokes?

You do not need to apply the Podge thickly, as you will be adding multiple coats. Leave approximately an hour’s drying time between coats, and if you see any brush strokes you are unhappy with once each layer is dry, sand them out using super-fine sandpaper, and wipe down with a duster afterwards.

How do you Modge podge without smudging?

Plaid Enterprises (the company that makes Mod Podge) recommends spraying one very light coat of fixative, waiting for it to dry, then spraying one additional coat. Read the specific instructions on the cans for drying time (normally 2-3 hours) and spray distance. You’ll want to find a spray that is 1. permanent, 2.

Why does my Mod Podge look streaky?

Causes of Streaking in Decoupage Finish Applying glue over almost dry glue. This pulls the dry glue away from the surface and creates streaks. In the future, let wet glue dry even if it means skipping an area. It may appear streaky because some areas have thick amounts of glue and some may be missing glue.

Should I water down Mod Podge?

Although the majority of our readers should be fine just using their Mod Podge directly from the tub, some people may need to thin it. Just remember, always use water to thin your Mod Podge and only use it in a maximum ratio of one part water to four parts Mod Podge.

Can I use Mod Podge over Sharpie?

Yes, you can use mod podge over Sharpie markers. You may use the matte finish or gloss finish. They both work well on Sharpie markers. A mod podge is a sealer or a glue that is often used in finishing decoupage art.

Can Mod Podge be thinned with water?

To thin your Mod Podge you simple need to add your glue to a suitable mixing container, add some water in a ratio of four parts Mod Podge to one part water and mix it. This tends to let you thin your Mod Podge while still keeping its consistency good enough to not end up with issues in its adhesive properties.

Can you apply Mod Podge with a sponge?

Apply a medium coat of Mod Podge to the surface. Add a protective coat of Mod Podge to the project using a sponge or flat brush. Allow to dry and then repeat. Let dry before using.

Why is my Mod Podge not drying clear?

Why did my Mod Podge not dry clear? Mod Podge doesn’t dry clear when clumping happens, i.e., when too much of it is applied. Mod Podge also appears white if you apply the next layer without letting the first one dry. Mod Podge also doesn’t dry clear if you live in a cold/humid climate.