How do I reset my HP PSC 1350 printer?

Perform a power reset.

1. Press the On/Resume button ( ) to turn on the product.
2. With the product turned on, disconnect the power cord from the rear of the product.
3. Unplug the power cord from the wall outlet.
4. Wait at least 15 seconds.
5. Plug the power cord back into the wall outlet.

Why is my HP Smart Printer not printing?

Make sure your devices are properly connected with each other, and the network or the cable you use to connect these devices is normal. You can also try restarting your HP printer. Turn it off completely and unplug the power cord, leave it for a couple of minutes, and then plug the cord back and power on the printer.

How do I reset my HP PSC 1400 printer?

Solution one: Reset the All-in-One With the power on, disconnect the power cord from the rear of the product. Wait 30 seconds. Reconnect the power cord to the rear of the product.

How do I reset my HP PSC 1315 printer?

Step one: Perform a power reset

1. With the printer turned on, disconnect the power cord from the rear of the printer.
2. Unplug the power cord from the wall outlet.
3. Wait at least 15 seconds.
4. Plug the power cord back into the wall outlet.
5. Reconnect the power cord to the printer.
6. Turn the printer on.

How do I reset my HP PSC 2410 printer?

Printer Reset

1. Press and hold cancel button.
2. Partial Reset: # 3, press and hold pound key along with the 3 key.
3. Semi Total Reset: # 6.
4. Total Reset: # 9.

How do I scan on HP 1400?

Press the “Scan” button, located at the bottom of the control panel. Wait for the device to finish scanning the document, then click on the button labeled “Done” or “Finish;” your computer launches the HP Image Zone application and displays the results of your scan.

How do I reset my HP PSC 2355 all in one printer?

Reset the printer While the printer is on, unplug the power cord from the rear of the printer and from the wall outlet (or other power source like a power strip). Wait at least 15-20 seconds, and then plug the cord back into the wall outlet first, and the printer second.