How do I connect my antenna to balun?

The eyelet on either side is used to connect to the antenna wire. Usually you would make a loop with the end of the antenna wire through the eyelet and then wrap the loose end around the antenna wire. The pig tail lead from the balun is then wrapped around the antenna wire and soldered.

What kind of balun is used for dipoles?

The best balun for the Windom or Off-Center Fed Dipole is a 4:1 ratio current balun.

How do you feed a dipole antenna?

Feeding a dipole antenna. Ideally, a half-wave dipole should be fed using a balanced transmission line matching its typical 65–70 Ω input impedance. Twin lead with a similar impedance is available but seldom used and does not match the balanced antenna terminals of most radio and television receivers.

How does a balun transformer work?

Balun transformers are used to convert an unbalanced signal to a balanced signal and vice versa. Commonly used in telephone lines, transmitters, and more, baluns optimize the flow of AC signals and transform impedance between coaxial cable and balanced loads.

What are the different types of baluns available?

Types of balun

• Classical transformer type.
• Autotransformer type.
• Transmission-line transformer type.
• Delay-line type.
• Radio and television.
• Video.
• Audio.
• Other applications.

Whats the difference between a balun and a UNUN?

A Balun is used to match a balanced line to an unbalanced line. An Unun is used to match an unbalanced line to another unbalanced line. This is a 4:1 Current Balun. The only difference between the Unun and Balun is how you connect the feed line.

How do you test a balun?

A straightforward way to test a 4:1 balun is as follows:

1. Disconnect the output side of the balun from your antenna or ladder line.
2. Locate a NON INDUCTIVE (Carbon composition, for example) 200 ohm resistor and connect it directly across the output terminals of the balun.

https://www.youtube.com/watch?v=zhsXIyq64Wc